Darkmoon LUX Build Plate for Bambu Lab Printers
The wait is over! The Darkmoon LUX build plate for Bambu Lab is finally here! Make your prints STUNNING with a highly reflective surface layer on top of exceptional adhesion!
Print all kinds of materials, from PLA and TPU to ABS and PC! Take your print farm to the next level by presenting your customers with high quality, reflective bottom surfaces!
Note: Materials other than PLA and TPU recommend light glue application.
Reflective Bottom Surface
Smooth PEI
Darkmoon LUX
Learn more
Recommended Settings
Here are some good starting points for various materials. Please note that if you print using a material other than PLA or TPU, glue will likely be required. The glue is used for release from the plate and sometimes for additional adhesion. PVA glue sticks spread with water or IPA are recommended.
PETG always requires glue for release or permanent damage to the build plate can be expected.
Users should assume that glue is required outside of PLA and TPU and may experiment with small prints in far corners of the build plate if they want to see if glue may not be required.
Damage to the build plate can be mitigated by gently roughing the surface with sand paper. Please see the Darkmoon LUX Build Plate User Guide for more information on how to maintain, clean, and service your LUX build plate.
Settings
Bed Temp: 55-60°C | Glue:No
Bed Temp: 70-80°C| Glue:Always
Bed Temp: Ambient| Glue:No
Bed Temp: 100-110°C| Glue:Yes
Bed Temp: 100°C| Glue:Yes
Bed Temp: 100-110°C| Glue:Yes